kb:hardware:elegoo_satrun_3_ultra
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| kb:hardware:elegoo_satrun_3_ultra [2025/04/22] – robertkuyper | kb:hardware:elegoo_satrun_3_ultra [2025/04/22] (current) – robertkuyper | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| ^ Z-axis resolution | 0.01mm | | ^ Z-axis resolution | 0.01mm | | ||
| ^ X-Y resolution | 19x24μm(11520x5120)| | ^ X-Y resolution | 19x24μm(11520x5120)| | ||
| + | |||
| + | ===== Machines ===== | ||
| + | |||
| + | ==== Printer 4 ==== | ||
| + | |||
| + | ^ Firmware | V1.5.4 | | ||
| + | |||
| + | This is just a standard Saturn 3 Ultra. The only modification is a 3d printed bracket to drain resin off of the build plate after printing. | ||
| ===== Manuals ===== | ===== Manuals ===== | ||
| {{ : | {{ : | ||
kb/hardware/elegoo_satrun_3_ultra.1745332394.txt.gz · Last modified: 2025/04/22 by robertkuyper
