Differences

This shows you the differences between two versions of the page.

--- kb:hardware:prusa_i3_mk3s_plus [2025/04/22] – robertkuyper
+++ kb:hardware:prusa_i3_mk3s_plus [2025/04/22] (current) – robertkuyper
@@ Line 23: / Line 23: @@
 ==== Printer 2 ====
+^ Firmware | V3.14.1 |
 This printer is a standard printer. The only upgrade is a Garolite bed to improve bed adhesion and release.
@@ Line 28: / Line 30: @@
 ==== Printer 3 ====
-This printer is equipped with a custom heated chamber and upgraded nylon parts. I also moved the electronics (other than the steppers) out of the enclosure. This chamber supports up to 80C, but to prevent the steppers from overheating I do not exceed 60C. This printer is being retired for the QIDI.
+^ Firmware | V3.14.1 |
+This printer is equipped with a custom heated chamber and upgraded nylon parts. I also moved the electronics (other than the steppers) out of the enclosure. This chamber supports up to 80C, but to prevent the steppers from overheating I do not exceed 60C. This printer is being retired from the chamber and returned to factory configuration. All future high temperature prints will be done on the QIDI.
 ===== Manuals =====

FTG Wiki