kb:software:orca_slicer
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| kb:software:orca_slicer [2025/04/23] – created robertkuyper | kb:software:orca_slicer [2025/04/23] (current) – robertkuyper | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| The development velocity on this project is great, so most shiny new features that come to other open source slicers also make their way to Orca quickly. | The development velocity on this project is great, so most shiny new features that come to other open source slicers also make their way to Orca quickly. | ||
| + | |||
| + | ===== Calibration ===== | ||
| + | |||
| + | I usually run the calibration in this order after first calibrating the nozzle height on the printer itself: | ||
| + | - Temperature | ||
| + | - Max flow rate | ||
| + | - Flow Rate | ||
| + | - Pressure Advance | ||
| + | - Retraction | ||
| + | - VFA (Vertical Fine Artifacts) | ||
| + | |||
| + | They provide a detailed guide that has more advanced calibration [[https:// | ||
| + | |||
kb/software/orca_slicer.1745434825.txt.gz · Last modified: 2025/04/23 by robertkuyper
