FTG Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Paddle Tail Swim Bait ======

====== About ======

The goal of this project was to create a prototype of a 12" paddle tail swim bait and a mold for small production runs. I usually work in parametric modeling, so this was an experience in surface modeling. I worked with Aaron to translate his idea into a suitable cad model. The goal of this mold was to be used as both a pour and an injection mold for plastisol.

====== Build ======

To create the mold, I took the body and created a second surface around it that represented the minimum material thickness suggested by the manufacturer. I created a body around this outer surface to create a shell. I make the shell on my [[kb:hardware:qidi_xmax_3|QIDI X-Max 3]] and printed the bait as a plug on my [[kb:hardware:elegoo_satrun_3_ultra|Elegoo Saturn 3 Ultra]]. After attaching a few pieces of copper wire to the plug to provide air vents and a clear coat to prevent the resin from inhibiting the cure of the silicone, I assembled the shell and the plug into the initial mold. Silicone was mixed, degassed, and poured into the initial mold. 

After removing the plug, we were left with a skin mold with an added plastic shell for rigidity and sealing. The plastisol is melted and poured into the silicone mold to create the final bait. 

====== Lessons Learned ======

  * breather vents must be sized based on the viscosity of the casting medium
  * it is easier to design a sealing surface in the shell than to seal a mold after the fact
  * weight based measurement is superior to volume based measurement
FTG Wiki

User Tools

Site Tools

Page Tools
